Hot air welding machine - LC-3000

Hot air welding machine

This product is for PVC, PE and other materials can be hot melt coated membrane plane designed for splicing.

When printing inkjet printers margins than the screen, you need to split after printing stitching, as well as printing are enhanced with the edge of the screen, Qian side, cable, wrapped in rope, etc., are traditionally used 502 and its derivatives glue and other adhesive means that there are many disadvantages, as follows: there is laminated slow, bonding strength is not enough, the screen easy to dirty, low efficiency, difficult to grasp and easy to operate, wasting time, when connected to large flat wide require larger workplaces. In particular, easy blistering after a period of wrinkles, resulting in uneven surface because the air temperature by the large, when the low temperature bonding effect is more unhappy.

Field of application

LC-15 smart type: Suitable for advertising industry, inkjet fabric, inkjet fabric, light box cloth, Knife cloth, mesh cloth PVC, PE hot melt plastic membranes welding process.

Main technical details

Rated voltage: AC110-240V Frequency: 50-60Hz

Power: 1000-3000W Temperature scope: 0-500°C

Speed scope: 1-15m/min Sepcification: 41*25*20cm

Weight: 15-20Kg Splicing width: 2-5cm

Characterics

No glue splicing, temperature adjustable speed, with a feedback temperature sensor, real-time monitoring and control temperature (usually the market adjusted voltage, adjust the wind speed, temperature is not constant). No matter how long mosaic images,welding mosaic result will not change. With seting up a air flowing switch,it welds thick pvc easyily.

Operation procedures

1, First of all,lighten up the spraying cloth, target the sew.(2-5cm),and fix the cloth on the ground with glue or tape.

2, Insert the power(picture),turn the handle to the left,till the spout is straight-line with the wheel.The turn the black button to the right ,adjust the speed, usually put it on 2.After adjust the speed,turn the handle to the right till the spout leave the ground.Then it stops.

3, Adjust the temperature.Turn on the temperature button(turn the golden button to the right,it make the voice “Ka”.Then press the temperature up and down button,adjust the temperature according to the thickness and durable of the cloth,usually put it between300°Cand350°C.Or you can put some materials in the spout,if the materials melt immediately and shouldn’t scorch.It is the proper temperature.

4, After adjust the temperature and speed,put the edge of the right-wheel in a level with the edge of sew.When the actual temperature reach to your set temperature,turn the handle to the left till the spout insert into the sew totally.The machine beginstowalk.Splicing begins..

5, During splicing,if the spout melt the spraying cloth. Fist you should turn black button to the right a little,or you can turn down the temperature.(choose one from the two ways) in that way,it won’t melt the cloth.But you shouldn’t turn the button in very urgent speed,or it will make the machine can’t weld or damage the cloth.

6, Before using,please find a proper temperature and speed.If slow,it will damage the cloth;if fast,it may stick not so fasten,so it is important to adjust the temperature and speed.

7, On the completion of splicing ,turn the handle to the right ,till the spout leave the spraying cloth totally.At this time,you can turn off the temperature button.But you couldn’t turn off the power cord and the power button, in case the heat damage the heat gun,and make the machine couldn’t work.You must wait till its actural temperature reach to the lowest.

8, Don’t use the machine in wet weather.The working place must be dry and flat.Pay attention to the fire, the machine should have technical person to operate. The working voltage is 110V-240V(two types) To open the machine,you should be responsible for the result yourself.